Infrastructure:Sysadmin Handbook: Difference between revisions
Jump to navigation
Jump to search
imported>Pew Redirected page to Sysadmin Handbook |
imported>Pew No edit summary |
||
| Line 1: | Line 1: | ||
This page describes how to build the infrastructure from scratch, as well manage it in general. | |||
== Networking == | |||
* Set up physical boxes based on the [[Infrastructure:Diagram|Diagram]] | |||
* Determine the ip addresses based on [[Infrastructure:Network|Network]] | |||
=== Router === | |||
Configure /etc/network/interfaces: | |||
<nowiki> | |||
# v6 | |||
iface $EXTERNAL_IF inet6 auto | |||
iface $INTERNAL_IF inet6 static | |||
address $INTERNAL_IPv6 | |||
netmask 128 | |||
# Enable internal network to access router's external v6 address | |||
pre-up ip route add $EXTERNAL_IPv6 via $INTERNAL_IPv6 | |||
# Enable NDP Proxying so internal boxes get SLAAC | |||
pre-up echo 1 > /proc/sys/net/ipv6/conf/all/forwarding | |||
pre-up echo 2 > /proc/sys/net/ipv6/conf/all/accept_ra | |||
# VTLUUG Private Network v4 | |||
iface $INTERNAL_IF inet static | |||
address $INTERNAL_IPv4 | |||
netmask 255.255.255.0 | |||
# Additional IPs | |||
iface $EXTERNAL_IF inet static | |||
address $EXTERNAL_IPv4 | |||
gateway 128.173.88.1 | |||
broadcast 128.173.91.255 | |||
netmask 255.255.252.0 | |||
# Nat Settings | |||
# TODO this probably doesn't work | |||
pre-up tc action nat egress 10.99.0.0/24 $EXTERNAL_IP | |||
# Enable ARP Proxying so internal v4 address are accessible | |||
pre-up echo 1 > /proc/sys/net/ipv4/conf/all/proxy_arp | |||
pre-up echo 1 > /proc/sys/net/ipv4/ip_forward | |||
# Route internal v4 addresses | |||
ip route add $JOEY_EXTERNAL_IPv4/24 dev $INTERNAL_IF | |||
ip route add $CRASHANDBURN_EXTERNAL_IPv4/24 dev $INTERNAL_IF | |||
ip route add $SCZI_EXTERNAL_IPv4/24 dev $INTERNAL_IF | |||
ip route add $ACIDBURN_EXTERNAL_IPv4/24 dev $INTERNAL_IF | |||
ip route add $ZEROCOOL_EXTERNAL_IPv4/24 dev $INTERNAL_IF | |||
ip route add $MIRROR_EXTERNAL_IPv4/24 dev $INTERNAL_IF | |||
</nowiki> | |||
Next, set up NDP proxying | |||
Configure /etc/ndppd.conf: (May not already exist) | |||
<nowiki> | |||
# Rather than only listenting on each individual IPv6 address, we | |||
# simply forward all soliciations. The main advantage is that we | |||
# don't have to add any additional routing rules if a new internal | |||
# device is added. | |||
route-ttl 30000 | |||
address-ttl 30000 | |||
# External interface to listen on | |||
proxy $EXTERNAL_IF { | |||
router yes | |||
timeout 500 | |||
autowire no | |||
keepalive yes | |||
retries 3 | |||
promiscuous no | |||
ttl 30000 | |||
# Prefix to listen on | |||
rule ::0/ { # TODO might change prefix | |||
# Internal interface to forward everything to | |||
iface $INTERNAL_IF | |||
autovia no | |||
} | |||
} | |||
</nowiki> | |||
Now start '''and''' enable ndppd.service. | |||
=== Everything Else not run under oVirt === | |||
==== Debian ==== | |||
Configure /etc/network/interfaces: | |||
<nowiki> | |||
# v6 | |||
iface $INTERFACE inet6 auto | |||
auto $INTERFACE | |||
iface $INTERFACE inet static | |||
address $INTERNAL_IPv4 | |||
gateway 10.99.0.1 | |||
netmask 255.255.255.0 | |||
# Additional IPs - Only do this if this box has an external IP | |||
iface $INTERFACE inet static | |||
address $EXTERNAL_IPv4 | |||
gateway 128.173.88.1 | |||
netmask 255.255.252.0 | |||
</nowiki> | |||
==== Centos ==== | |||
Configure /etc/sysconfig/network-scripts/ifcfg-$INTERFACE: | |||
<nowiki> | |||
ONBOOT="yes" | |||
NM_CONTROLLED="no" | |||
BOOTPROTO="static" | |||
IPADDR0="$INTERNAL_IPv4" | |||
GATEWAY0="10.99.0.1" | |||
NETMASK0="255.255.255.0" | |||
# Addition IPs - Only do this if this box has an external IP | |||
IPADDR1="$EXTERNAL_IPv4" | |||
GATEWAY1="128.173.88.1" | |||
NETMASK1="255.255.252.0" | |||
</nowiki> | |||
== Other stuff == | |||
Revision as of 02:27, 2 January 2018
This page describes how to build the infrastructure from scratch, as well manage it in general.
Networking
Router
Configure /etc/network/interfaces:
# v6
iface $EXTERNAL_IF inet6 auto
iface $INTERNAL_IF inet6 static
address $INTERNAL_IPv6
netmask 128
# Enable internal network to access router's external v6 address
pre-up ip route add $EXTERNAL_IPv6 via $INTERNAL_IPv6
# Enable NDP Proxying so internal boxes get SLAAC
pre-up echo 1 > /proc/sys/net/ipv6/conf/all/forwarding
pre-up echo 2 > /proc/sys/net/ipv6/conf/all/accept_ra
# VTLUUG Private Network v4
iface $INTERNAL_IF inet static
address $INTERNAL_IPv4
netmask 255.255.255.0
# Additional IPs
iface $EXTERNAL_IF inet static
address $EXTERNAL_IPv4
gateway 128.173.88.1
broadcast 128.173.91.255
netmask 255.255.252.0
# Nat Settings
# TODO this probably doesn't work
pre-up tc action nat egress 10.99.0.0/24 $EXTERNAL_IP
# Enable ARP Proxying so internal v4 address are accessible
pre-up echo 1 > /proc/sys/net/ipv4/conf/all/proxy_arp
pre-up echo 1 > /proc/sys/net/ipv4/ip_forward
# Route internal v4 addresses
ip route add $JOEY_EXTERNAL_IPv4/24 dev $INTERNAL_IF
ip route add $CRASHANDBURN_EXTERNAL_IPv4/24 dev $INTERNAL_IF
ip route add $SCZI_EXTERNAL_IPv4/24 dev $INTERNAL_IF
ip route add $ACIDBURN_EXTERNAL_IPv4/24 dev $INTERNAL_IF
ip route add $ZEROCOOL_EXTERNAL_IPv4/24 dev $INTERNAL_IF
ip route add $MIRROR_EXTERNAL_IPv4/24 dev $INTERNAL_IF
Next, set up NDP proxying Configure /etc/ndppd.conf: (May not already exist)
# Rather than only listenting on each individual IPv6 address, we
# simply forward all soliciations. The main advantage is that we
# don't have to add any additional routing rules if a new internal
# device is added.
route-ttl 30000
address-ttl 30000
# External interface to listen on
proxy $EXTERNAL_IF {
router yes
timeout 500
autowire no
keepalive yes
retries 3
promiscuous no
ttl 30000
# Prefix to listen on
rule ::0/ { # TODO might change prefix
# Internal interface to forward everything to
iface $INTERNAL_IF
autovia no
}
}
Now start and enable ndppd.service.
Everything Else not run under oVirt
Debian
Configure /etc/network/interfaces:
# v6
iface $INTERFACE inet6 auto
auto $INTERFACE
iface $INTERFACE inet static
address $INTERNAL_IPv4
gateway 10.99.0.1
netmask 255.255.255.0
# Additional IPs - Only do this if this box has an external IP
iface $INTERFACE inet static
address $EXTERNAL_IPv4
gateway 128.173.88.1
netmask 255.255.252.0
Centos
Configure /etc/sysconfig/network-scripts/ifcfg-$INTERFACE:
ONBOOT="yes" NM_CONTROLLED="no" BOOTPROTO="static" IPADDR0="$INTERNAL_IPv4" GATEWAY0="10.99.0.1" NETMASK0="255.255.255.0" # Addition IPs - Only do this if this box has an external IP IPADDR1="$EXTERNAL_IPv4" GATEWAY1="128.173.88.1" NETMASK1="255.255.252.0"